Parts

Redevelopment and optimisation of moulded parts

We always realise customer demands in the shortest time to the best cost-benefit ratio.  During development as an important step in our value-chain we decide how the future products shall look like and how the can be produced economically.

Our entire production process is IT-supported and the departments development and construction together with mouldmaking, injection moulding, assembling and packaging are connected and integrated into the automated workflow through a common data base. The result are short cycle- and production times. Our Pro/Engineer and Unigraphics programs are responsible for quick results in redevelopment and optimisation of plastic parts. Based on 3D modelling or rheological calculations, prototyping is consistently possible and can be discussed with the customer. Here the decision is made how the part must look like for the tool construction, to provide serial production without any problems.

This processing step is supported by Simcon Cadmold-Software. This software allows different rheological simulations, to have a target-oriented follow up processing. This includes filling properties, warpage, orientation, pressure loss, lunker/sink marks, air entrapments, weld lines as well as detailed cycle times. For this reason we can avoid problems for sure and optimise moulds even before they have been build.